Rotating Torque Tester

NTS-6
Rotating Torque Tester

NTS-6 is a motorized rotating torque tester that measures rotating dynamic torque while turning test pieces. Check the rotating torque, smoothness of rotation and components of small precision motors, such as, gearbox, bearings, oil seals, etc. Torque data can be continuously output via RS-232 enabling you to display a torque profile using data acquisition software.

Peak, Real Time and Continuous Output measuring modes (selectable)

Programmable high/low setpoints for Go/No go testing

RS-232C output n Both CW and CCW operation

Model	Range
NTS-S1	1.40 - 14.00 Oz-in
NTS-S2	2.80 - 28.00 Oz-in
NTS-S5	7.00 - 70.00 Oz-in

Alternative Unit Calculator- recasts values in above table (units in RED can be selected on gauge. Other units for reference only)

Accuracy	±1% F.S., 1LSD
Measuring Range (at the time of Track)	S1: 3.0~100mNm S2: 3.0~200mNm S5: 0.030~0.5Nm
Max. Rotational Speed (no-load)	S1: 85 rpm S2: 30 rpm S5: 13 rpm
Display	4 digit LCD display
Operation	Both CW and CCW motorized rotation
Measuring modes	PP: Peak Mode displays PEAK torque value that will not change until a higher value is measured. GO: Real Time Mode displays TRANSIENT torque values. RG: Output Torque Data every 1/100 seconds.
Measurement start time	Can be set up to 1 second in 0.1 second increments.
Measuring time	Time can be programmed between 1 and 20 seconds.
Go/No go testing	Programmable High and Low values; Green lamp (OK solid, NG blinking).
External input/output	Signal output (open collector): Go and No Go Data output: RS-232C (9600 baud) External start switch input
Data memory	400 data
Power supply	AC100V~240V
Bit size	4mm diameter